I have finally finished the basic layout of my fmp project which has the path going up leading to a room.
For the last part of its creation I first decided to create some barriers, to stop my character from involuntarily falling off.
To do this i took a section of the path and copied it with (ctrl d). I then used the scale tool to readjust the size, first shrinking it inwards and then expanding it.
Once this was done I then moved it to the right of the path, and clipped it to the side using the vector tool. After repeating this step all the way to the top of the path, I then went back to the first section and duplicated the first newly added barrier and shifted it to the right side. Continuing this same process until the end of the path I finally finished the barriers.
Onto the final step, to make some walls for the building at the top of the path. For this i similarly duplicated its base squashed it down then stretched it upwards using the scale tool, afterwards clipping it using the vector to the left side, and then doing the same with a copied version and clipped it to the right side. This completed the left and right walls.
For the back wall I did somethings a bit differently because its size was different from the others, so once I had copied the base and changed its size suitable for a wall, to make it the same size as the others i readjusted them all and choose a good whole number for a part of the size.
Now that all sizes of the wall where the same I could now clip on the back wall finishing the building for now.
For the last part of its creation I first decided to create some barriers, to stop my character from involuntarily falling off.
To do this i took a section of the path and copied it with (ctrl d). I then used the scale tool to readjust the size, first shrinking it inwards and then expanding it.
Once this was done I then moved it to the right of the path, and clipped it to the side using the vector tool. After repeating this step all the way to the top of the path, I then went back to the first section and duplicated the first newly added barrier and shifted it to the right side. Continuing this same process until the end of the path I finally finished the barriers.
Onto the final step, to make some walls for the building at the top of the path. For this i similarly duplicated its base squashed it down then stretched it upwards using the scale tool, afterwards clipping it using the vector to the left side, and then doing the same with a copied version and clipped it to the right side. This completed the left and right walls.
For the back wall I did somethings a bit differently because its size was different from the others, so once I had copied the base and changed its size suitable for a wall, to make it the same size as the others i readjusted them all and choose a good whole number for a part of the size.
Now that all sizes of the wall where the same I could now clip on the back wall finishing the building for now.
Comments
Post a Comment